Stepper Motor Control Device SMCD10
Description
The SMCD10 Stepper Motor Control Device is designed for controlling the low power stepper motors in applications where high speed and high torque is not very important. The SMCD10 device is mainly recommended for precision transfer systems, e.g. manipulators, sample transfer systems etc.
Additional information
The SMCD10 is a 1/4 width 19” rack mounting unit (3U height).
Technical data
Supply voltage | 110V or 230V, 50/60Hz, specify at order |
Stepper Motor | Two-phase hybrid stepper motor unipolar or bipolar control standard stepper motor 200 step/revolution. Other resolutions of steps available on request. Programmable motor current 0 - 2,5A at 24V per motor coil for "Stop" and "Run" State. Programmable full and half step mode (default half step) |
Encoder | Standard 400 pulses/revolution. Incremental encoder used for standard motors with 200 steps/revolution in full step mode, or 400 steps/revolution in half step mode. Other step resolutions available on request |
Programmable Inputs | 10 programmable inputs can be used as limit switches, reference sensors or other safety switches. The inputs signals can immediately affect the control of the stepper motor (limit the maximum movement range, setting the reference position for encoder), or can be read transparently by the computer |
Stepper motor control functions | Programmable Velocity. Acceleration and Deceleration time. Programmable Motor coil current for "Stop" and "Run" state. Programmable Half or full steps mode. Programmable and control the motor system backlash offset. Advanced motor movement tracing with external encoder. |
Communication Interface (option) | 2 wire EIA-485 - Half duplex serial interface and communication protocol with CRC check redundancy sum, allows for connecting a few devices together using one 2 wire cable and controlling them with a computer program |
Dimensions [mm] | 116 x 133 x 240 (W x H x D) (1/4 width, 3 units height) mounted in the 19" rack |
Weight, approx | 2,2 kg |